Some Commander SE travel codes – Health Guild News

0
28


Machines are highly programmed robots that depend on their code to program correctly. If these codes do not exist, the machines will face a problem of operation and correct operation, causing breakdowns and distractions. Travel codes are an exception for these use cases. They are a hash product of a password that helps to know one’s own identity without collecting any data about the user. Adding a specific password will allow the person to sign their posts with the travel code created from the password.

With robotics, and when working with robotics, it’s helpful to have a backup plan. This is where travel codes come in handy when operating or working with robotics and sophisticated technology. Because? Because travel codes act as a kind of fault switch for when you have problems with your machinery or technology. By having the travel codes, you can overcome these technical problems, towards the solution.

The machines use the travel code, being the most secure option, to restart or run their machines.

The Control Techniques Commander SE Microdrive series is an AC loop open loop vector, which offers good fit and a small footprint. This is a reliable series that will probably last a long time. However, you may encounter one of the HF travel codes. These codes can be found due to any internal fault in the unit. Typically, these travel codes can be solved by turning off and letting the driver down for about 5 minutes and then running it.

Each machine has its own unique set of travel codes. This is to make sure you can access one specific machine over another. For the Control Techniques Commander SE, here are some examples of their special travel codes. Read these codes to learn more about travel codes and their uses.

HF72 – LEVEL 3 OVERRUN: Overflow of level 3 of the user code.

The user interface code (control PCB microprocessor) runs at different priority levels and each task has a set time to complete its tasks. If for some reason the code is unable to complete its task within the allotted time, it will fire HF70, HF71 or HF72.

HF73 – DSPCOMMS: Communications between processor and DSP do not work

The two microprocessors talk to each other via 2-cable RS485 serial communications. If this internal serial communication link fails, the unit will activate the HF73.

HF83 – ELECTRICAL BOARD CODE: Incorrect electrical board code.

The DSP reads the power PCB voltage to determine the correct amount of kW. If this voltage is different from the expected value, the drive will trip HF83.

HF98 -INTCRASH: User code interrupt error.

While the user code is running, it is continuously checking that the data it receives is valid and that the addresses are valid, and so on. If it detects a problem, it will fire one of the 6 codes above: HF88, HF90, HF91, HF92, HF96 or HF98.

In case you need more information visit Electrical MRO website.





Source link